The slide wire rope electric hoist installation simple and practical method
Electric wire rope hoists are widely used. Especially the mill site electric the gourd slip line failure occur, the inconvenience to the repair work. This paper introduces a simple and practical installation of our own design.
1, electric hoist mounted in a U-shaped track, for this feature, the cable layout in the middle of the track, I-beam upper. Cable using q ~ 10mm wire rope or bar, ends with a basket of flowers bolts fastening.
2, the slip ring for two rings linked together, there is a margin, to avoid cable scratch cards. The steering ring of two rings connected with a bolt, freely rotatable.
3, a steering ring at one end sets in the cable, leaving a good motor lead rubber line is fixed at the bottom of the steering ring. Multiple sliding ring wear to one end of the cable, then rubber sleeve line segment is fixed to the lower end of the slip ring. The distal end connected to the electric motor, and can move freely. After terminating the power supply.
4, in the traction of the motor, the steering ring as the center, and traction ropes for linear or circular motion.
5, the straight track above method can be used.
This method is simple, low cost. Use since 2002, there has been no failure. Eliminate the slip line is bad in the past, lead short circuit, open circuit, and other issues. Is now widely used to good effect.