Electric wire rope hoist installation in orbit
General electric wire rope hoist is installed in the U-shaped track.
Against this feature, the rope is arranged in the middle of the track, that is, the H-beam upper. Vertebral cable using 10mm wire rope or round, the top baskets bolt fastening; slip ring two rings interlocking, there is a margin, to avoid cable scratch cards. The steering ring two rings connected with bolts, rotate freely; sets a steering ring at one end tightrope, after leaving a good motor leads rubber line is fixed at the bottom of the steering ring.
Then multiple one end of the slip ring to wear on the cable, then rubber set of line segments fixed at the lower end of the slip ring. Electric hoist the front end connected to the motor, can rotate freely, after termination in the power supply. Traction motor, as the center of the steering ring, pulling the cable in a straight line or circular motion.